Sargent & Greenleaf 3007 Direct Drive
Summary
- relockers: A relock device plate normally attaches to the lock body; where it uses the cover screw, the screw must…
- mounting: Storage unit may be any material provided the lock gets an electrical ground; mounting surface sturdy, smooth…
- Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc. · SG Document 630-890
Specifications
relockers
A relock device plate normally attaches to the lock body; where it uses the cover screw, the screw must engage at least 4 threads (longer 8-32 screws may be substituted) with no screw exceeding the tapped hole depth.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
mounting
Storage unit may be any material provided the lock gets an electrical ground; mounting surface sturdy, smooth and flat, with 1/4-20 or M6 screw holes.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
Lock body screws: use only the supplied screws, at least four full threads engaged, torque 30 to 40 in.-lb (33.9 to 45.2 dNm); no lock washers or thread sealant. Keypad base screws no more than 15 in.-lb.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
Cut the spindle to the door thickness plus 13/16 in., route the cable through it, and seat it on the lock splines. The screw locking the drive plate on the keypad rear is taken out and thrown away before use.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
battery type
Two 9 V batteries in the keypad base; the clip will not latch if a battery is inserted backward; the chrome ring lifts for battery access.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
bolt dimensions
Bolt free movement up to 0.352 in. (8.95 mm), of which 0.109 in. sits outside the lock case edge; keep a gap of 0.150 in. (3.8 mm) minimum from the case end to the bolt-blocking part.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
install test
Function test: make sure the boltwork does not bind on the lock bolt in the fully locked position; relieve a bind by removing a little material from the blocking bar opening. Run three or more open-door trials before the door is shut.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
specifications
Install sheet for the Model 3007 Direct Drive USB Audit Lock (S&G Audit Lock 2.0 family); documents 630-889 (3006, revised 9/25/15) and 630-890 (3007).
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
Bolt end pressure: designed to withstand at least 225 lb. (1000 N); boltwork or cam designs must never put more than 225 lb. (1000 N) of side pressure on the bolt.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
Printed 'lock is designed to move' load: 2.5 lb. (11.12 N) continuous, 10 lb. (44.48 N) maximum.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
spindle diameter
Spindle (cable) hole at least 0.375 in. (9.5 mm) and at most 0.406 in. (10.3 mm), free of burrs.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
supplied parts
Parts list: base, two 9 V cells, keypad unit, Direct Drive lock body, chrome trim ring, fasteners, a cable and a spindle shaft.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
notes
Following the sheet is a condition of the warranty and of EN 1300 compliance. The container has to shield the lock body from physical attack and keep security-relevant parts out of reach with the door open.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
Codes: avoid personal data (birth date, street number, phone number) and easily guessed codes; replace the factory default with an individual code before service.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.
The sheet carries a Confidential notice: proprietary to Sargent & Greenleaf, with publication or duplication prohibited.
Sargent and Greenleaf Model 3007 Direct Drive USB Audit Lock Installation Instructions, Document 630-890 · Sargent & Greenleaf, Inc.